Actions

KAmodMAG3110FC

Description

KAmodMAG3110FC is a module with magnetic field sensor MAG3110FC from NXP. The board is equipped with a Pmod I2C standard connector and a KAMAMI connector, that allow to easy connection of the module to the evaluation kits. Due to its small dimensions, the product can be used in many development projects, while the Pmod loop connector allows to connect the boards in the series.

KAmodMAG3110FC modul.png
Basic features and parameters
  • MAG3110FC chip from NXP
    • Magnetic field measurement in the range of ±1000μT
    • Sensitivity 0.1μT
    • Noise level: 0.25μT rms
    • I2C bus
    • Programmable interrupt output
    • Maximum measurement frequency: 80Hz
  • Connector compatible with the Pmod standard, allows serial connection of Pmod I2C modules
  • The connector complies with the KAMAMI standard
  • Embedded jumpers activating pull-up on I2C bus lines
  • Embedded jumper connecting the INT line of the chip to the INT line of Pmod connectors
  • Possibility to supply voltage from 2.1...3.6V through Pmod connector and 2.1... 5.5V through KAMAMI connector
  • Mounting holes with a diameter of 2.5mm
  • Dimensions: 61.2mm x 20.3mm x 10mm
Standard equipment
Code Description
KAmodMAG3110FC
  • Assembled and launched module
Electrical schematics
KAmodMAG3110FC schemat.png
Output description - Pmod standard connector
KAmodMAG3110FC obrys zlacze.png
JP1 (male connector) JP2 (female connector) Function
VDD VDD Power supply of module (max. 3,6 V)
GND GND
SDA SDA Data line of I2C bus
SCL SCL Clock line of I2C bus
RST RST -
INT INT Interrupt line INT2
Output description – KAMAMI standard connector
KAmodMAG3110FC obrys zlacza kamami.png
Pin number Function
1 (VDD_5V) Power supply of module (max. 5,5 V)
2 (SCL) Clock line of I2C bus
3 (SDA) Data line of I2C bus
4 (GND) Ground
I2C bus lines

The KAmodMAG3110 module is equipped with jumpers allowing to connect pull-up resistors to the positive power pole to the I2C bus line. The jumpers give the possibility of independent enabled of the pull-up for the SDA and SCL lines.

KAmodMAG3110FC obrys i2c.png
Interrupt line INT1

The KAmodMAG3110FC module has been equipped with a jumper enabling connection of the INT2 interrupt output line to the Pmod compatible connector. Thanks to the possibility of disconnecting the MAG3110FC interrupt line from Pmod connectors, the user does not have to worry about the consequences of possible conflicts resulting from the connection of Pmod-compatible module modules with different logic states.

KAmodMAG3110FC obrys int.png
Dimensions
KAmodMAG3110FC wymiary PCB.png
External links