KAmodRPi Pico Expansion: Difference between revisions
From Kamamilabs.com - Wiki
| Line 9: | Line 9: | ||
===== Basic parameters ===== | ===== Basic parameters ===== | ||
* 2x20 | * 2x20 screw terminal connectors | ||
* 2x20 pin | * 2x20 male pin header extending Pico pins | ||
* 2x20 pin | * 2x20 female pin header extending Pico pins | ||
* 40x male-female jumper wires, in | * 40x male-to-female jumper wires, in various colors, each 17 cm lon | ||
* Reset button | * Reset button | ||
* Dimensions: 59 x 61 mm | * Dimensions: 59 x 61 mm | ||
Latest revision as of 08:43, 2 November 2024
Description
KAmodRPi Pico Expansion - Raspberry Pi Pico Expansion Board with Screw Terminals
A universal board for Raspberry Pi Pico that outputs the computer's GPIO pins to male and female goldpin connectors, as well as screw terminals with labeled pins. The board is equipped with a standard female connector for direct connection to Raspberry Pi Pico. It has two sets (one male and one female) of 2x20 pin headers that allow you to connect additional expansion modules, plus all Raspberry Pi Pico pins are on screw connectors, which makes prototyping much easier and faster, without the need for soldering.
.JPG)
Basic parameters
- 2x20 screw terminal connectors
- 2x20 male pin header extending Pico pins
- 2x20 female pin header extending Pico pins
- 40x male-to-female jumper wires, in various colors, each 17 cm lon
- Reset button
- Dimensions: 59 x 61 mm
Standard equipment
| Code | Description |
|---|---|
| KAmodRPi Pico Expansion 40 x F-M connection cable |
Assembled and started module Complete set of connection cables |
.JPG)
Electrical connection diagram
The electrical connections between the individual points are shown in the figure below.
Raspberry Pi Pico module mounting method
The Raspberry Pi Pico module can be mounted using goldpins as shown in the photos.
Dimensions
The dimensions of the KAmodRPi Pico Expansion board are: 61x59 mm
