Difference between revisions of "KAmodBAR-I2C"
Anna Kubacka (talk | contribs) (Created page with "__jzpdf__ ====== Description ====== KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 do 115 kPa...") |
Anna Kubacka (talk | contribs) |
||
(2 intermediate revisions by one other user not shown) | |||
Line 1: | Line 1: | ||
__jzpdf__ | __jzpdf__ | ||
====== Description ====== | ====== Description ====== | ||
− | KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 | + | KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 to 115 kPa |
− | + | ||
<center> | <center> | ||
[[File:kamodbar_skos_1.jpg|none|400px|thumb|center]] | [[File:kamodbar_skos_1.jpg|none|400px|thumb|center]] | ||
</center> | </center> | ||
− | ===== | + | ===== Basic features ===== |
− | * Pressure sensor | + | * Pressure sensor MPL115A2 from Freescale |
− | * Pressure measurement in range from | + | * Pressure measurement in range from 50 to 115kPa |
− | * Accuracy 1 | + | * Accuracy 1 kPa |
− | * Power supply voltage | + | * Power supply voltage 2.375 do 5.5V |
* I2C interface | * I2C interface | ||
Latest revision as of 14:36, 22 September 2020
Contents
Description
KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 to 115 kPa
Basic features
- Pressure sensor MPL115A2 from Freescale
- Pressure measurement in range from 50 to 115kPa
- Accuracy 1 kPa
- Power supply voltage 2.375 do 5.5V
- I2C interface
Standard equipment
Code | Description |
---|---|
KAmodBAR-I2C |
|
Schematic
View of board
I2C interface
MPL115A2 chip is equipped with I2C interface available on Con3, Con4 i Con5. Con4 i Con5 connectors are compatible with Kamami development board standard (e.g. ZL5PIC, ZL15AVR, ZL27ARM, ZL29ARM, ZL30ARM, STM32Butterfly2). To connect module to the boards can be used CAB_HU04-30 cable.
Module configuration
Con6 connector makes possible to enable MPL115A2 chip or to block I2C interface. To enable MPL115A2 should be connect SHDN to GND (by putting on a jumper on pins 3 i 4 Con6 or connecting to the microcontroller and setting low state). To block I2C interface should be connect to pin CS_RES voltage from VCC (by putting on a jumper on pins 1 i 2 Con6 or connecting to the microcontroller and setting high state).