KAmodHTS221: Difference between revisions
From Kamamilabs.com - Wiki
No edit summary |
|||
| (One intermediate revision by the same user not shown) | |||
| Line 24: | Line 24: | ||
*Mounting holes 3mm | *Mounting holes 3mm | ||
*Module size (without connector): 24mm x 15mm x 3mm | *Module size (without connector): 24mm x 15mm x 3mm | ||
<br> | <br> | ||
===== Standard equipment ===== | ===== Standard equipment ===== | ||
<center> | <center> | ||
| Line 41: | Line 42: | ||
===== Electrical schematic ===== | ===== Electrical schematic ===== | ||
<center> | <center> | ||
[[File:KAmodHTS221_schemat.png|none| | [[File:KAmodHTS221_schemat.png|none|600px|thumb|center]] | ||
</center> | </center> | ||
===== Outputs description ===== | ===== Outputs description ===== | ||
Latest revision as of 16:51, 1 November 2024
Description
KAmodHTS221 is a module, which allow to make a measurement of humidity and temperature. Thanks to embedded voltage regulator and logic level translator, it can be used in embedded system with power supply 2.5 - 5.5V. Module KAmodHTS221 bases on humidity / temperature sensor HTS221 from STMicroelectronics. The characteristic features of this sensor are: measurement possibility in range 0 - 60°C or air humidity in range 0 - 100%.
Basic features and parameters
- Humidity / temperature sensor HTS221 from STMicroelectronics company
- Measurement range: 0 - 100% (humidity) / 0 - 60°C (temperature)
- Humidity measurement accuracy: ± 6% (0 - 100% RH) / ± 4.5% (20 - 80% RH)
- Temperature measurement accuracy: ± 1°C (0 - 60°C) / ± 0.5°C (15 - 40°C)
- Power supply voltage: 2.5V - 5.5V
- Power consumption: 9mA
- Measurement data rate (ODR): 1 - 12.5[Hz]
- ADC converter resolution: 16 bits
- Communication interface: SPI / I2C
- Embedded voltage regulator and logic level translator (SDA and SCL lines)
- Data ready output (DRDY)
- Place for soldering of pin header
- Mounting holes 3mm
- Module size (without connector): 24mm x 15mm x 3mm
Standard equipment
| Code | Description |
|---|---|
| KAmodHTS221 |
|
Electrical schematic
Outputs description
 |
JP1 | I2C | SPI |
|---|---|---|---|
| +3.3V | Module power supply | ||
| +VIN | |||
| GND | |||
| SDA/SDI/SDO | SDA | SDI/SDO | |
| SCL/SPC | SCL | SPC | |
| SDO/SA0 | SA0 | - | |
| GND | Additional ground | ||
| CS | CS | CS | |
| DRDY | Data ready signalization | ||