KAmodBAR-I2C: Difference between revisions
From Kamamilabs.com - Wiki
Anna Kubacka (talk | contribs) No edit summary |
|||
| Line 2: | Line 2: | ||
====== Description ====== | ====== Description ====== | ||
KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 to 115 kPa | KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 to 115 kPa | ||
<center> | <center> | ||
[[File:kamodbar_skos_1.jpg|none|400px|thumb|center]] | [[File:kamodbar_skos_1.jpg|none|400px|thumb|center]] | ||
Revision as of 12:36, 22 September 2020
Description
KAmodBAR-I2C is a module based on pressure sensor MPL115A2 from Freescale. It makes possible to measurement pressure in range 50 to 115 kPa
Basic features
- Pressure sensor MPL115A2 from Freescale
- Pressure measurement in range from 50 to 115kPa
- Accuracy 1 kPa
- Power supply voltage 2.375 do 5.5V
- I2C interface
Standard equipment
| Code | Description |
|---|---|
| KAmodBAR-I2C |
|
Schematic
View of board
I2C interface
MPL115A2 chip is equipped with I2C interface available on Con3, Con4 i Con5. Con4 i Con5 connectors are compatible with Kamami development board standard (e.g. ZL5PIC, ZL15AVR, ZL27ARM, ZL29ARM, ZL30ARM, STM32Butterfly2). To connect module to the boards can be used CAB_HU04-30 cable.
Module configuration
Con6 connector makes possible to enable MPL115A2 chip or to block I2C interface. To enable MPL115A2 should be connect SHDN to GND (by putting on a jumper on pins 3 i 4 Con6 or connecting to the microcontroller and setting low state). To block I2C interface should be connect to pin CS_RES voltage from VCC (by putting on a jumper on pins 1 i 2 Con6 or connecting to the microcontroller and setting high state).
