KAmodL3GD20: Difference between revisions

Revision as of 07:31, 23 September 2020

Opis

KAmodL3GD20 is a module with MEMS chip L3GD20 type. It allows to make measurement of angle velocity in range ±250 / ±500 / ±2000 angle per second. Module can be used for measurement of the object inclination and also as complement for magnetometer or accelerometer (e.g. KAmodLSM303) in precision measurement device of physical values. Communication with the module is realize by I2C or SPI interface.

Basic features and parameters

L3GD20 chip (MEMS gyroscope) from STMicroelectronics
Measurement range of gyroscope: range ±250 / ±500 / ±2000 dps
Power supply voltage: 2.5V - 5.5V
Sleep mode and low power mode
Communication interface: SPI / I2C
Embedded voltage regulator and logic level translator (SDA and SCL lines)
Interrupt line INT1 on connector
Interrupt FIFO (INT2) line on connector and data ready output (DRDY)
Place for soldering of pin header
Mounting holes 3mm
Module size (without connector): 27mm x 15mm x 3mm

Standard equipment

Code	Description
KAmodL3GD20	Assembled and launched module Pin header (male and angle) for soldering

Electrical schematic

Outputs description

JP1	I2C	SPI 3-wire	SPI 4-wire
+3.3V	Module power supply
+VIN
GND
SDA/SDI/SDO	SDA	SDI/SDO	SDI
SCL/SPC	SCL	SPC	SPC
SDO/SA0	SA0	-	SDO
CS	CS	CS	CS
INT2/DRDY	Interrupt 2 output / data ready signal
INT1	Interrupt 1 output

@@ Line 2: / Line 2: @@
 ====== Opis ======
 [https://kamami.pl/kamod-kamami/557724-kamodl3gd20-modul-zyroskopu-mems-z-ukladem-l3gd20-firmy-stmicroelectronics.html KAmodL3GD20] is a module with MEMS chip L3GD20 type. It allows to make measurement of angle velocity in range ±250 / ±500 / ±2000 angle per second. Module can be used for measurement of the object inclination and also as complement for magnetometer or accelerometer (e.g. KAmodLSM303) in precision measurement device of physical values. Communication with the module is realize by I2C or SPI interface.
 <center>
 [[File:KAmodL3GD20_moduł.png|none|400px|thumb|center]]