KAmodRS485

Description

KAmodRS485-3V3 and KAmodRS485-5V0 are modules with the ST485 / MAX485 chip, allowing the conversion of the UART bus to RS485. The board is equipped with a standard Pmod UART connector, allowing for easy connection of the module to development kits. Thanks to its small dimensions, the product can be used in many development projects.

Basic Features and Parameters

• MAX485 / ST485 chip
  • Convert UART signal to RS485
  • Low quiescent current: 300uA
• Connector compatible with the Pmod UART standard
• Built-in jumper to activate 120Ohm terminating resistor
• Can be supplied with voltage from 3V-3.6V (3V3 version) or 4.75V-5.25V (5V0 version)
• Mounting holes with a diameter of 2.5 mm
• Dimensions: 61.2mm x 20.3mm x 10mm

Standard Equipment

Code	Description
KAmodRS485	Assembled and running module

Wiring diagram

Pinout description - Pmod standard connector

	JP1 (male connector)	Function
	VDD	Power supply of the module
	GND
	DE	Activating the encoder
	RO	Receiver output (TX line)
	DI	Encoder input (RX line)
	RE	Activate the listener

Termination Resistor Jumper

The KAmodRS485 module is equipped with a jumper that allows to connect a 120Ohm terminating resistor to the RS485 bus line.

RS485 bus outputs

The KAmodRS485 module outputs are led out on the screw and goldpin connector, which allows easy connection of the system to the bus.

External Dimensions

External Links

• ST485 datasheet
• ST3485 system datasheet