Actions

KAmodEXP1

From Kamamilabs.com - Wiki

Revision as of 13:51, 22 September 2020 by Anna Kubacka (talk | contribs)

Description

KAmodEXP1 module allows easy connection of 8-bit bidirectional I/O port expander to any system with SPI interface


Basic features
  • MCP23S08 I/O port expander (Microchip)
  • 8 GPIO bidirectional lines
* SPI interface (up to 10MHz)

  • Configurable SPI address (4 combinations)
  • Configurable interrupt output
  • 25 mA sink/source capability per I/O
* Operating voltage 1,8...5,5VDC


* Kamami standard SPI connector (compatible with most of Kamami evaluation boards)


Standard equipment
Code Description
KAmodEXP1
  • Assembled module


Schematics
Board layout
Connectors

SPI lines (without pull-up resistors!) are available on Con1 and Con2 connectors. Pinouts are shown on figure below.

Expander GPIO lines are available on 10-pin IDC connector. Pinout is shown on figure below.

Address lines

MCP23S08 address lines (A1 and A0) are connected to JP0 and JP1 jumpers. Both address lines have pull-up resistors.

Module connection

KAmodEXP1 is equipped with two connectors Con1 and Con2, that can be used to connect module to KAMAMI evaluation boards with SPI connector (STM32Butterfly, ZL30ARM, ZL15AVR, ZL16AVR, ZL5PIC etc.). For this purpose you can use CAB_HU06-30 cable available at kamami.com.