KAmodL3GD20 (PL)

Opis

KAmodL3GD20 is a module with MEMS chip L3GD20 type. It allows to make measurement of angle velocity in range ±250 / ±500 / ±2000 angle per second. Module can be used for measurement of the object inclination and also as complement for magnetometer or accelerometer (e.g. KAmodLSM303) in precision measurement device of physical values. Communication with the module is realize by I2C or SPI interface.

none|400px|thumb|center

Basic features and parameters

• L3GD20 chip (MEMS gyroscope) from STMicroelectronics
• Measurement range of gyroscope: range ±250 / ±500 / ±2000 dps
• Power supply voltage: 2.5V - 5.5V
• Sleep mode and low power mode
• Communication interface: SPI / I2C
• Embedded voltage regulator and logic level translator (SDA and SCL lines)
• Interrupt line INT1 on connector
• Interrupt FIFO (INT2) line on connector and data ready output (DRDY)
• Place for soldering of pin header
• Mounting holes 3mm
• Module size (without connector): 27mm x 15mm x 3mm

Standard equipment

Code	Description
KAmodL3GD20	Assembled and launched module Pin header (male and angle) for soldering

Electrical schematic

none|800px|thumb|center

Outputs description

center|200px	JP1	I2C	SPI 3-wire	SPI 4-wire
	+3.3V	Module power supply
	+VIN
	GND
	SDA/SDI/SDO	SDA	SDI/SDO	SDI
	SCL/SPC	SCL	SPC	SPC
	SDO/SA0	SA0	-	SDO
	CS	CS	CS	CS
	INT2/DRDY	Interrupt 2 output / data ready signal
	INT1	Interrupt 1 output

External links

• L3GD20 chip datasheet
• Article "Żyroskop L3GD20 - obsługa w Arduino" on Hobbyspace.pl