KA-Nucleo-Multisensor (PL)

Description

KA-Nucleo-Multisensor is an expansion board (shield). It extends functionality of development board from STM32 Nucleo series. Shield has ST Morpho connectors and was equipped i.a. with 4-Digit 7-Segment LED Display, four RGB LEDs, accelerometer LIS35DE, pressure sensor LPS25HB and also digital thermometer DS18B20.

none|400px|thumb|center

Basic features and parameters

Shield that extends functionality of STM32 Nucleo-64 series boards
On-board 7-Segment Display (4-Digit, four decimal points)
On-board four tricolour LEDs
Embedded MEMS accelerometer type LIS35DE
- Acceleration measurement in three axis
- Measurement range: ±2g/±8g
- Functional of “Click” recognition
- Interface: SPI
Embedded MEMS pressure sensor type LPS25HB
- Measurement range: from 260 to 1260 mbar absolute pressure range (260 - 1260 hPa)
- Measurement resolution: 0,01 hPa RMS
- Measurement output data rate: (ODR): 1 – 25 [Hz]
- ADC converter resolution: 24 bits
- Interface: I2C
Embedded temperature sensor DS18B20
- Temperature measurement in range -55°C do +125°C
- Temperature measurement precision w range -10°C do +85°C: ±0,5°C
- Interface: 1-Wire
Embedded photoresistor for light intensity measurements in environment
On-board two user push-buttons
On-board miniUSB connector, which allows data transfer by using GPIO pins (PA11, PA12)
Size: 70 x 54 x 28 mm
Weight: 28 g

Standard equipment

Code	Description
KA-Nucleo-Multisensor	Assembled and launched module

Electrical schematics

none|800px|thumb|center

External links

Kategoria:Moduł peryferyjny KAmod (Kamami) Kategoria:Zawartość