KAmodLPS25HB (PL)

Description

KAmodLPS25HB is a module for atmospheric pressure measurement in range 260 - 1260hPa. It bases on absolute pressure sensors LPS25HB. It is characterized by i.a. wide range and high resolution of measurement. Communication with module can be realized by I2C or SPI interfaces. Thanks to embedded voltage regulator and logic level translator, module can be used in system with power supply 2.5 - 5.5V.

none|400px|thumb|center

Basic features and parameters

• LPS25HB chip (MEMS pressure sensor) from STMicroelectronics
• Measurement range: from 260 to 1260mbar of absolute pressure (260 - 1260hPa)
• Measurement resolution: 0,01hPa
• Power supply voltage: 2.5V - 5.5V
• Power consumption: 2.5mA
• Measurement data rate (ODR): 1-25[Hz]
• ADC converter resolution: 24 bits
• Communication interface: SPI / I2C
• Embedded voltage regulator and logic level translator (SDA and SCL lines)
• Interrupt output / data ready output
• Place for soldering of pin header
• Mounting holes 3mm
• Module size (without connector): 27mm x 15mm x 3mm

Standard equipment

Code	Description
KAmodLPS25HB	Assembled and launched module Pin header (male and angle) for soldering

Electrical schematic

none|800px|thumb|center

Outputs description

center|200px	JP1	I2C	SPI 3-wire	SPI 4-wire
	+3.3V	Module power supply
	+VIN
	GND
	SDA/SDI/SDO	SDA	SDI/SDO	SDI
	SCL/SPC	SCL	SPC	SPC
	SDO/SA0	SA0	-	SDO
	CS	CS	CS	CS
	INT2	Interrupt output / data ready signal

External links

• LPS25HB chip datasheet
• Article ‘KAmodLPS25HB - czujnik ciśnienia atmosferycznego wraz z KAmduino UNO’