KAmodLPS331 (PL)

Description

KAmodLPS331 is a module, which bases on absolute pressure sensors LPS331. It is characterized by i.a. wide range and high resolution of measurement. Module allows to measurement of absolute pressure in range 260 - 1260hPa. Thanks to embedded voltage regulator and logic level translator, module can be used in system with power supply 2.5 - 5.5V.

none|400px|thumb|center

Basic features and parameters

• LPS331AP chip (MEMS pressure sensor) from STMicroelectronics
• Measurement range: from 260 to 1260mbar of absolute pressure (260 - 1260hPa)
• Measurement resolution: 0,02hPa RMS
• Power supply voltage: 2.5V - 5.5V
• Power consumption: 7mA
• Measurement data rate (ODR): 1-25[Hz]
• ADC converter resolution: 24 bits
• Communication interface: SPI / I2C
• Embedded voltage regulator and logic level translator (SDA and SCL lines)
• Interrupt output / data ready output /FIFO flag
• Place for soldering of pin header
• Mounting holes 3mm
• Module size (without connector): 27mm x 15mm x 3mm

Standard equipment

Code	Description
KAmodLPS331	Assembled and launched module Pin header (male and angle) for soldering

Electrical schematic

none|800px|thumb|center

Outputs description

center|200px	JP1	I2C	SPI 3-wire	SPI 4-wire
	+3.3V	Module power supply
	+VIN
	GND
	SDA/SDI/SDO	SDA	SDI/SDO	SDI
	SCL/SPC	SCL	SPC	SPC
	SDO/SA0	SA0	-	SDO
	CS	CS	CS	CS
	INT2/DRDY	Interrupt 2 output / data ready output
	INT1/DRDY	Interrupt 2 output / data ready output

External links

• LPS331 chip datasheet
• Library for Arduino
• [Project] 'KAmodLPS331- czujnik ciśnienia atmosferycznego i KAmduino UNO' on MIKROKONTROLER.PL page