Actions

KAmodMIC ELECTRET

Revision as of 10:46, 23 September 2020 by Anna Kubacka (talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Description

KAmodMIC_ELECTRET is a module with electret microphone KPCM6B type. Thanks to embedded amplifier with hundredfold amplification of signal, output voltage can be measurement with using e.g. ADC converter in microcontroller. Module can be used by noise sensor or  monophonic VU-meter as well.

KAmodMIC ELECTRET modul.png
Basic features and parameters
  • Microphone KPCM6B-P type from KEPO
  • Embedded LMV321L amplifier from STMicroelectronics
  • Rail-to-rail amplifier type with hundredfold amplification of signal from microphone
  • Power supply voltage: 2.7V - 6V
  • Output voltage of module in silence is equal to a half of power supply voltage
  • Embedded low-pass filter with cutoff frequency 10.6kHz
  • Place for soldering of pin header
  • Mounting holes 3mm
  • Module size (without connector): 22.5mm x 9.3mm x 8mm
Standard equipment
Code Description
KAmodMIC_ELECTRET
  • Assembled and launched module
  • 3-Pin header (male and angle) for own soldering
Electrical schematic
KAmodMIC ELECTRET schemat.png
Outputs description
KAmodMIC ELECTRET obrys PCB.png
JP1 Function
VCC Module power supply
GND Ground of power supply / signal
OUT Signal output
Signal output

KAmodMIC_ELECTRET module has embedded amplifier, which can increase the signal from electret microphone hundredfold. Constant value of amplifier is a half of power supply voltage and signal amplitude depends on noise level in environment. On photo below is shown examples sinusoidal sound, which was received with using KAmodMIC_ELECTRET (power supply 3.3V).

KAmodMIC ELECTRET przebieg na wyjsciu.png
External links