Actions

Difference between revisions of "ZL14PLD"

(Created page with "__jzpdf__ ===== Description ===== DipPLD module was developed to make easier common using of CPLD chips by constructors, which can not or will not invest in automated componen...")
 
 
Line 6: Line 6:
 
[[File:Zl14pld_skos_czarny.jpg|none|400px|thumb|center]]
 
[[File:Zl14pld_skos_czarny.jpg|none|400px|thumb|center]]
 
</center>
 
</center>
 
+
 
===== Basic paremeters =====
 
===== Basic paremeters =====
 
* CPLD XC2C256 chip (256 macrocells) from CoolRunner-II family in VQFP100 package
 
* CPLD XC2C256 chip (256 macrocells) from CoolRunner-II family in VQFP100 package

Latest revision as of 10:20, 24 September 2020

Description

DipPLD module was developed to make easier common using of CPLD chips by constructors, which can not or will not invest in automated component mounting system of elements with small pitch (0.5mm).

Zl14pld skos czarny.jpg
Basic paremeters
  • CPLD XC2C256 chip (256 macrocells) from CoolRunner-II family in VQFP100 package
  • 16 lines with buffers adjusted to 5V signals
  • Embedded clock frequency adjusted generator and oscillator 32.768kHz
  • Module adapted to using with ZL15PLD board
Standard equipment
Code Description
ZL14PLD
  • Assembled and launched module with XC2C256 chip
Electrical schematic
Zl14pld sch.png
Position of the most important elements of module
Zl14pld pcb png.png
Module output description
Zl14pld zlacza.png
JTAG connector

Module is equipped with 10-pins IDC connector. To the connector can be connected programer/configurator ISP (e.g. ZL11PRG or ZL4PRG). Position of IDC connector and signals was presented on the picture below.

Zl14pld jtag.png
Buffers adjusted to the 5V signals

Module is equipped with two 8-pins buffers ST2378, which make possible to lead to the programmable chip 16 lines with signals 5V or 3.3V. Configuration of buffers depends on jumpers BANK1 (JP3) and BANK2 (JP4). Description of configuration was presented below.

Signal level I/O lines Jumper configuration
3,3 V p28, p29, p30, p32, p33, p34, p35, p36 BANK1 in position 3,3 V (1-2)
5 V p28, p29, p30, p32, p33, p34, p35, p36 BANK1 in position 5 V (2-3)
3,3 V p68, p70, p71, p72, p73, p74, p76, p77 BANK2 in position 3,3 V (1-2)
5 V p68, p70, p71, p72, p73, p74, p76, p77 BANK2 in position 5 V (2-3)


Zl14pld bufory.png
Clock signal sources

ZL12PLD module is equipped with two clock signal sources: oscillator 32.768kHz and adjusted clock generator based on 555 timer, which frequency can be controlled with potentiometer F_GCK1 (P1).

Zl14pld gen555.png