TIBBOcomp - Kamamilabs.com - Wiki
 Actions

TIBBOcomp

Description

TIBBOcomp is a base board that allows easy start with miniature programmable Ethernet modules and a WiFi network. It has an embedded converter RS232 voltage levels, buttons and LEDs of any purpose.


Plytka Soyter skos.JPG


Basic features
  • Power supply 5 V via mini USB connector
  • Embedded voltage level converter RS232
  • 8 LEDs and 8 buttons are available to the user
  • 3 status LEDs including power supply signaling
  • 9-pin RS232 and RJ45 female socket
  • Possibility to install Tibbo modules: EM500, EM1202 and GA1000


Standard equipment
Code Description
TIBBOcomp
  • Assembled TIBBOcomp board


Schematic
TIBBOcomp schemat.png


View of board
TIBBOcomp pcb.png


Mini USB connector (power supply)

This connector is used only to power the TIBBOcomp board. All necessary voltage converters are already placed on the board of the development kit.


TIBBOcomp pcb gniazdo usb.png


TIBBOcomp schemat mini usb.png


RS232 connector

The board is equipped with a DB9 RS232 connector together with an embedded voltage level converter that make possible to connect selected Ethernet module via a serial port to a PC. Through the serial port we also have the possibility of programming Ethernet modules.


TIBBOcomp pcb gniazdo rs232.png


TIBBOcomp schemat zasilanie.png


RJ45 connector

The board is equipped with an RJ45 connector to connect the EM500 or EM1202 module to the Ethernet network. Through this socket, you can also configure the network module.


TIBBOcomp pcb gniazdo rj45.png


TIBBOcomp schemat RJ45.png


LEDs and buttons

The board has been equipped with 8 LEDs and 8 buttons of any purpose, which are connected to the module GPIO ports. In addition, each LED can be physically disconnected by removing the jumper from the JP5 connector. Diodes D1 and D2 are status diodes and diode D11 indicates power supply voltage of the board.


TIBBOcomp pcb LED.png


TIBBOcomp schemat LED.png
EM1202 module connector

Mod1 connector it is used to connect a programmable Ethernet EM1202 module.


TIBBOcomp pcb Mod1.png


TIBBOcomp schemat Mod1.png


Plytka plus Tibbo EM1202 .JPG


EM500 module connector

Mod3 connector is used to connect EM500 module.


TIBBOcomp pcb Mod3.png


TIBBOcomp schemat Mod3.png


Plytka plus Tibbo GA1000.JPG


GA1000 module connector

Mod2 connector is used to connect the WiFi module (GA1000), which can cooperate with the programmable EM1202 or EM500 Ethernet module, increasing the capabilities of these modules to work in a wireless network. Connecting the GA1000 module to the EM500/1202 module requires the setting of jumpers JP1, JP2, JP3, JP4, JP6 in the position GA1000+EM500.


TIBBOcomp pcb Mod2.png


TIBBOcomp schemat Mod2.png


Plytka plus Tibbo EM500.JPG