SilicaProg: Difference between revisions
From Kamamilabs.com - Wiki
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
__jzpdf__ | __jzpdf__ | ||
===== Description ===== | ====== Description ====== | ||
SilicaProg is a universal programmer-configurator for ISP that allows programming of CPLD and FPGA from Xilinx. It cooperates with i.a. the free WebPack toolkit, it is compatible with the standard Xilinx programmer called Parallel Cable III (DLC 5). | SilicaProg is a universal programmer-configurator for ISP that allows programming of CPLD and FPGA from Xilinx. It cooperates with i.a. the free WebPack toolkit, it is compatible with the standard Xilinx programmer called Parallel Cable III (DLC 5). | ||
<center> | <center> | ||
[[File:silica_prg.jpg|none|400px|thumb|center]] | [[File:silica_prg.jpg|none|400px|thumb|center]] | ||
Latest revision as of 10:11, 2 November 2024
Description
SilicaProg is a universal programmer-configurator for ISP that allows programming of CPLD and FPGA from Xilinx. It cooperates with i.a. the free WebPack toolkit, it is compatible with the standard Xilinx programmer called Parallel Cable III (DLC 5).
Basic features and equipment of programmer
- compatibile with Parallel Cable III (DLC 5) from Xilinx;
- cooperate with Xilinx toolkit (i.a.. WebPack);
- power supply: 3,3...5,5 V (supplied from the programmed chip);
- programs CPLD systems and configurators of FPGA, configures FPGA – all from Xilinx;
- output iterface: JTAG;
- output connector: IDC10 (signal placement compatible with boards and modules dipPLD from Kamami.pl);
- LED indicates power supply enabling;
- connects to the printer port PC.
Standard equipment
| Code | Description |
|---|---|
| SilicaProg |
|
Placement of components
The placement of the most important programmer elements is shown in the figure below.
JTAG connector
The placement of signals in the JTAG output socket is shown in the figure below. It is compatible with the standard used in all sets with PLD systems produced by Kamami.pl. The length of the connection cable should not exceed 1 m (the cable included with the programmer is 30 cm long).
Cooperation with PC
The programmer is connected to the computer's parallel printer interface. It is not recommended to use between the PC connector and programmer additional extension cable. They may prevent the programmer from working correctly.