ZL30PRGv2-1

Nowoczesny programator-debugger z USB obsługujący interfejsy SWD (mikrokontrolery STM32). W pełni zgodny z programatorem-debuggerem ST-Link/V2-1 firmy STMicroelectronics. Ma również funkcję konwertera USB-UART.

wyposażony w złącze IDC20,
umożliwia programowanie i debugowanie pracy mikrokontrolerów STM32,
w pełni zgodny z interfejsem ST-Link/V2-1 (STMicroelectronics),
współpracuje z pakietami µVision (Keil), IAR Embedded Workbench (IAR), True Studio (Atollic), VX-toolset for ARM Cortex-M (TASKING),
wyposażony w gniazdo microUSB,
funkcja konwertera USB-UART (wyprowadzenia zgodne z KAmodRS),
zasilanie z USB,
możliwość uaktualniania firmware'u,
zakres napięć pracy układu docelowego:
- interfejs SWD: 1,65...3,6 V,
zakres temperatury pracy: 0...50°C.

Standard equipment

Code	Description
KA-NUCLEO-F411	Assembled and tested module

Electrical schematics

Microcontroller STM32F411CEU6

The board based on 32-bit microcontroller STM32F411CEU6 from STMicroelectronics in UFQFPN48 package. Chip has 512kB embedded Flash memory, 128kB RAM and can be running with frequency at 100 MHz. Microcontrollers GPIO lines are available on extension pin headers with Arduino UNO standard.

Attention! Microcontrollers pins: PA0(A0), PA4(A2), PA5(D13) and PB5(D4) don’t be a 5V tolerant pins. They shouldn’t be supply with voltage exceeding 3.3V

Power supply

KA-NUCLEO-F411CE board can be supply via both USB connector and external power supplier with connector 5.5 x 2.1. The board has embedded protection circuit against reverse voltage polarity.

USB communication

On board programmer compatible with ST-Link/V2-1 make possible programming and debugging of STM32F411CEU6 microcontroller. State of programmer is signalling by the bicolour LED D3 – correct connecting of programmer to PC is signalling by constant red colour of LED, communication between programmer and microcontroller by blinking red and green LEDs and orange LED colour indicates communication error.

User LED and RGB LED

KA-NUCLEO-F411CE board is equipped with two user LED – L3 LED (connected to D13 microcontrollers pin) and tricolour LED (with cathode connected to pins PB13…PB15 of microcontroller); both LEDs can be control by user program.

USB Host connector

Embedded microUSB connector on KA-NUCLEO-F411CE board is with microcontroller connected. That make possible to used microcontroller as USB Full Speed device.